Model

Wristpin (.866" Diameter) LC Engineering can supply replacement wrist pins and locks for our forged pistons. Wristpins are available in either standard thickness (.120") or "Turbo" version (.155"). These pins are designed to fit our forged pistons...

Water Block Plate (Center Of Head) If you are installing an Offenhauser intake (or if you are eliminating the heater core), there won't be room for the heater core outlet off the cylinder head. This water block plate goes in the center of the cylinder...

Exhaust Gasket OEM style gaskets offer the best possible seal for your stock manifold or header. All the LC Engineering headers are designed to use the factory gaskets. Traditional paper exhaust gaskets do not last as long as the factory style gaskets...

Crush Collar Replacement crush collar for the 6.7" Celica differential. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for these...

Fuel Filter A frequently overlooked tune-up component is the fuel filter. While modern gasoline is highly refined, contaminants can still get in fuel anywhere from the filling of the transport truck to particles in your own gas tank. Little bits of...

Oil Fitting (Block To Oil Filter) LC Engineering carries all the components you need to build your long block or service your old one. Specifications: 27mm Hex Head Thread pitch: 19mm x 1.5 (Block Side) & 3/4 - 16 (Filter Side) Contact...

Water Block Plate (Timing Cover Passenger Side) This block plate goes on the passenger side of the timing cover. Perfect for eliminating the unnecessary water hoses going around your engine compartment. Contact our Tech Support Line for...

Water Block Plate (Timing Cover Driver Side) This block plate goes on the driver's side back of the timing cover which is for deleting the factory heater return line on most 22's. Contact our Tech Support Line for further information at...

Fuel Injector Caps (Green Cap) These clear injector caps fit 3VZ V6 injectors. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (6). Contact our Tech Support Line for...

Intake Valve (Stainless Steel / 44mm) This is a stainless steel swirl polished valve that is 1mm over stock size. This valve is a perfect upgrade for a mildly built engine, and the best part is they will fit on the stock 20R valve...

Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 48mm long, heat treated and plated header mounting studs are stronger than stock. Kit Includes: (8)...