Model

Thermostat (180 Degree) Reduced engine temperatures add life to your engine and provide a denser air/fuel mixture which helps produce more horsepower. Consistent control of the engine temperature allows an engine to operate at its peak efficiency, no...

1 3/4" Radiator Cap (Small) This Sankei OEM style Japan Radiator Pressure Cap that directly replaces the factory caps. The cap is 100% Stainless Steel and is a 13 pound cap or 0.9 kg/cm. Toyota used two styles of radiator caps the small one that...

Hose Clamp for Radiator (Outlet #2) LC Engineering is now offering an OEM hose clamp for your radiator (specifically outlet #2). OEM Toyota Part #: 90467-38001 Contact our Tech Support Line for further information at 928-575-2174. Note:...

Water Block Plate (Under EFI Manifold) This water block off plate goes under the intake manifold on fuel-injected 22RE engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

PCV Relocation Kit If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

Hose Clamp for Radiator Inlet LC Engineering is now offering an OEM hose clamp for your radiator inlet. No part is to be over-looked now... No part to small. Don't see what you need? Call our sales team, they might be able to track it down for you...

Front CV Axle Outer Boot (Front) Replacement front axle shaft outer boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will...