Model

Oil Pan Hardware Kit (Silicone Seal) This oil pan hardware kit includes all the bolts and washers needed to install your oil pan and pick up tube. This hardware kit is designed to work with silicone seal pans only. This kit will not work with gasket...

h1 class="pdhead"Oil Pan Hardware Kit/h1 h2 class="pdhead"(Gasket Seal)/h2 p This oil pan hardware kit includes all the bolts and washers needed to install your oil pan and pick up tube. This hardware kit is designed to work with gasket seal pans only...

Pulley Bolt (Front Balancer) OEM Toyota front crank hub bolt fits all 2RZ and 3RZ engines. We recommend replacing the balancer bolt any time you replace the front balancer. OEM Toyota Part #: 90105-16041 Contact our Tech Support Line for...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Rear Inner Axle Seal Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support Line for...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

8" Oil Dipstick Tube Bracket (Shorty Style) OEM part direct from Toyota! Don't look any further for a new replacement dipstick Tube Bracket to replace your old one. This is the shorty style dipstick tube bracket found on most 22R and 22RE applications...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

Injector Harness Adapter (Denso to Bosch EV1) This injector harness adapter installs between the stock injector plug and a new fuel injector with no cutting or splicing required. This is the cleanest way for you to install an aftermarket fuel injector...

OEM Shifter Boot (Manual Transmission) It's common for the factory shift lever boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transmission shifter then into the transmission. This simple rubber...

OE Wheel Bearing Grease Seal (Front Hub) Fits in the back side of the front IFS hubs, will be needed anytime you repack or replace front wheel bearings. You will need two seals in order to do your truck. NOTE: Not for Solid Axle applications. For...

Gasket Set (Weber Adapter) Avoid or fix annoying vacuum leaks by replacing the gaskets between the plates the Weber 32/36 and 38 carb adapter. Over time gaskets become brittle and break. We recommend these gaskets to be replaced any time the adapter is...