OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

OEM "J" Bolt (Battery Hold Down) OEM Toyota "J" bolt for battery hold down bracket. OEM Toyota Part #: 74451-89103 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

10mm Rear Coil Spring Spacer (Old Man Emu) Features: Installs on the top of the rear coil spring. Designed to add 10mm lift to compensate for vehicle lean. NOTE: Sold Individually. Due to many supply chain issues, this product may be on backorder...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

Water Pump Gasket (OEM) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley without alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Street Valve Shim (Stock Bucket / 3.05mm) Street valve shims are used to shim the valve lash to obtain the proper valve lash specification that is required for the appropriate camshaft grind. On 2RZ and 3RZ engines, the cam rides directly on the shim...

Street Valve Shim (Stock Bucket / 3.10mm) Street valve shims are used to shim the valve lash to obtain the proper valve lash specification that is required for the appropriate camshaft grind. On 2RZ and 3RZ engines, the cam rides directly on the shim...