Model

Intake Manifold Gasket (Lower / 8 Port) LC Engineering offers the best quality gaskets possible for your Toyota engine. Over time, the factory gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs! This gasket...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

1/4" 90 Degree Fitting (Push-Lok to -4AN Swivel) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 90 degree fitting is used for the oil feed line at the turbo or block. Perfect for...

Front Balancer Seal New OEM quality harmonic balancer seal. Eliminate those pesky front oil leaks by replacing the old brittle seal with this new high-quality seal. OEM Toyota Part #: 90311-32020 Contact our Tech Support Line for further...

OEM PCV Valve Grommet This is an OEM Toyota 3VZ PCV valve grommet. OEM Toyota: 90480-18001 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not...

Wristpin Locks (.866" Diameter) This set of wrist pin locks is what is required to hold your connecting rod wrist pins in place. These are essential pieces that should not be overlooked. Always replace wrist pin locks when refreshing your motor...

Trail Gear Brake Line Clip & Mount (Rear Line Only) This brake line mount kit is designed to fit Trail Gear extended length brake lines. If you've added a little (or a lot) extra ground clearance and suspension travel, you probably have added some...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

Shackle Bolt (Greasable) LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them. NOTE: Bolt is M18 x 150mm. For use with Trail Gear...

Transfer Case Dust Flange Dust shield for use with triple drilled output flange. Keeps rocks and other trail debris from damaging seals behind the output flange on your transfer case. This product should not be used in a manner that violates Federal...

Inner Axle Seal When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your tool box for trail side repairs. This product should...

Power Steering Reservoir Bracket This Rock Assault Reservoir Bracket bolts right to the back of our Rock Assault Reservoir and allows you to either weld the other side of the bracket to your cage (coped for 1 1/2" tubing) or simply butt weld it to a...