Model

Reservoir Filter Bracket Our Rock Assault Reservoir Filter Bracket bolts right to the back of our Rock Assault Reservoir Filter Kit (into the pre-tapped holes) and allows you to either weld the other side of the bracket to your cage (coped for 1 1/2"...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Fuel Pump Tank Seal This is an OE fuel pump tank seal. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact...

Fuel Pump Lock Ring Seal If you find yourself replacing a fuel pump, now is the time to replace the lock ring seal as well. This is an OE fuel pump lock ring seal to help you through the job. Contact our Tech Support Line for further information...

OEM PCV Valve (Steel) This is an OEM Toyota 3VZ PCV valve. OEM Toyota: 12204-65010 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

Brake Caliper Hard Line (Left Side) This is the OEM hard line that goes from the caliper to the spindle. Tundra 2000-2006 / Sequoia 2002-2007 OEM Toyota Part #: 47318-0C020 Contact our Tech Support Line for further information at 928-575-2174...

Brake Caliper Hard Line (Right Side) This is the OEM hard line that goes from the caliper to the spindle. Tundra 2000-2006 / Sequoia 2002-2007 OEM Toyota Part #: 47315-0C020 Contact our Tech Support Line for further information at 928-575-2174...

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...

OEM Exhaust Manifold Stud When installing new aftermarket headers, new hardware should be used. An even clamping force is required to keep the header tight against the head in order to seal the exhaust gasket properly. The studs on your truck may be 20...

Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...

Pro Bronze Valve Guide Valve Guides are made of the highest quality manganese bronze material available. This provides additional clearance between retainer and seal for increased valve lift. Valve Guides provide excellent stability so they can be run...

Denso Iridium IK22 Spark Plug These 2 step colder plugs are recommended by URD if you are running the 7th Injector upgrade on a Supercharged 5VZ engine. If you are running the stock pulley (Low Boost) on the 5vz supercharger, Magnuson recommends...