Holley Fuel Pressure Regulator Gauge Kit (1-4 PSi / Carb Only) If you are running a Weber carburetor on your Toyota truck, this kit is a must-have and a great way to keep your fuel system running right. Weber carbs work best in the 2.5-3psi range...

Primary Idle Jet Holder (w/ O-Ring) This Weber jet holder holds the primary fat jet into the main housing on Weber 32/36 and 38 downdraft carburetors. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Secondary Idle Jet Holder (w/ O-Ring) This Weber jet holder holds the secondary skinny jet into the main housing on Weber 32/36 and 38 downdraft carburetors. Contact our Tech Support Line for further information at 928-575-2174. Note:...

Idle Jet Holder O-Ring These O-Rings seal the idle jet holder to the main carburetor housing. O-Rings can become brittle with age and cause annoying (and dangerous) fuel leaks. NOTE: O-Rings sold individually. Contact our Tech Support Line for...

Flex Coupler (2 1/2" x 6") To reduce the stress on your exhaust system, we have these flex couplers to weld or clamp onto your pipe. Under acceleration, your engine has a tendency to torque to one side. A flex coupler will allow the engine to torque...

Catalytic Converter (17.5″ x 2.25″ / CA Smog Legal) New Stainless Steel Catalytic Converter fits OEM or aftermarket exhaust systems. 2.25" (2 1/4") pipe and flanges make for a direct fit for most applications. Make sure to measure your factory...

Heat Riser Kit (Attaches Heat Riser To Air Cleaner) This kit is used to connect a heat riser tube to the stock air cleaner assembly. This kit can be used on any header with 1.5" primary tubes. Kit Includes: (3) Hose clamps (1) 1.5″ Standoff (1)...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

GT25R Turbo Inlet Gasket (Metal) A Stainless Steel inlet gasket for the GT25 turbos that we use in our CT20 conversion kit. For between the turbo manifold and the GT25 turbo or our adaptor and the GT25. Contact our Tech Support Line for further...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Street Distributor Cap (Clip Style) This is a OE style replacement distributor cap for the older clip style distributors.The cap is the smaller 3" cap vs the larger late model screw down caps that are 3 1/2". A must when changing spark plug wires...