Celica

K&N Filter Care Service Kit (Squeeze Red / 99-5050) K&N Recharger Kit 99-5050 is designed for cleaning your K&N oiled cotton air filter when it is time to be serviced. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil...

K&N Power Kleen Filter Cleaner (99-0621) K&N part 99-0621 is a 32 ounce pump spray bottle of Power Kleen Air Filter Cleaner. K&N Power Kleen is the only cleaner recommended to clean K&N cotton air filter elements. K&N 99-0621 Air Filter Cleaner will...

22RE Cold Start Injector Block Plate Kit (22RE EFI Intake Manifold) This kit is designed to allow you to safely block of the cold start injector and supply when you are upgrading your efi system to a stand alone fuel management. NOTE: For a complete...

Fuel Pump Block Plate Kit This block off plate blocks the hole on the front of the cylinder head where a manual fuel pump would mount. Perfect for if you are using an electric fuel pump on an engine that originally had a manual pump installed...

Turbo Wristpin LC Engineering can supply replacement wrist pins and locks for our forged pistons. Wristpins are available in either standard thickness (.120") or "Turbo" version (.155"). These pins are designed to fit our forged pistons only and are...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

Idle Speed Adjusting Screw (w/ O-Ring) Is your Idle Speed Screw loosening by itself keeping the motor from idling properly? Is it stripped out from all of the adjustments over the years? Is it even on the throttle body anymore or did it fall out? LC...

Front Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. It is recommended to use Anti-seize when installing...

PLX Gauge Ring Mount The 2 1/16" (52mm) gauge ring mount offers the perfect mounting solution for those that do not wish to drill into their dashboard or install a gauge cluster. This 2 1/16" gauge ring mount will fit any standard sized 2 1/16" gauge...

Manual Choke Kit (w/ Cable) If you are looking to convert your electric choke Weber 32/36 or 38 carbs to a manual choke application, look no further. Kit Includes: Cable Bracket Hardware Contact our Tech Support Line for further information...

Wristpin (.866" Diameter) LC Engineering can supply replacement wrist pins and locks for our forged pistons. Wristpins are available in either standard thickness (.120") or "Turbo" version (.155"). These pins are designed to fit our forged pistons...

Water Block Plate (Center Of Head) If you are installing an Offenhauser intake (or if you are eliminating the heater core), there won't be room for the heater core outlet off the cylinder head. This water block plate goes in the center of the cylinder...