Celica

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

D.U.I. Distributor Rotor This is the replacement rotor for the D.U.I. Distributors. Will only work with D.U.I. 4 Cylinder Distributors. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...

Clutch Slave Cylinder The clutch slave cylinder is typically located on the side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which pushes the slave cylinder shaft out to actuate the clutch...

OEM Radiator Fan Shroud Clip (1979-1998 4Runner/Pickup/Celica/Tacoma/T100) OEM Radiator Fan Shroud Clip. OEM Toyota Part #: 90468-06013 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...

Manual Choke Kit (w/ Cable) If you are looking to convert your electric choke Weber 32/36 or 38 carbs to a manual choke application, look no further. Kit Includes: Cable Bracket Hardware Contact our Tech Support Line for further information...

Fuel Pump Spacer (Mechanical Fuel Pump) This black plastic spacer installs between the manual fuel pump and the cylinder head. The spacer is needed to properly mount the fuel pump to get the correct stroke off the camshaft. Contact our Tech...

OEM Water Pump Gasket Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...

Rear Outer Axle Seal (Rubber) Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support...

-6AN Fuel Rail Fitting (Fuel Inlet) LC Engineering offers this fitting that threads into your stock fuel rail inlet on your 22RE/22RET. It comes with an O-ring and a crush washer. NOTE: M14 x 1.50 to -6AN fitting. We also sell replacement Fuel Rails...