2.5" Cooling Pipe
(Pre-Intercooler)
Get the most out of your intercooler with this special Pre-Intercooler Cooling Pipe. When compressed air leaves your turbocharger or supercharger, air temperature of 350°F is normal. You'll want to get this air...
3.0" Cooling Pipe
(Pre-Intercooler)
Get the most out of your intercooler with this special Pre-Intercooler Cooling Pipe. When compressed air leaves your turbocharger or supercharger, air temperature of 350°F is normal. You'll want to get this air...
Safety Auto Main Bearing Set
When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...
Rock Slider Mounting Kit
Our gusset kits include 3/16" thick plate steel for the frame and triangle corner gussets. This plate welds to the frame and the rock slider welds to the plate.
Kit Includes:
(8) plates
(8) gussets
This product should...
Trail Gear Rock Ripper Air Filter 5"
(Replacement)
This is the replacement air filter for the Tacoma 2.4Liter Extreme Rock Ripper Air Filter 5" kit, This filter is interchangeable with K&N filter RU-4600.
NOTE: For the precharger for this filter,...
Timing Belt Tensioner
(Mechanical)
This is a replacement timing belt tensioner for the 3.4L 5VZ V6. It is recommended to replace both the Belt Tensioner and timing belt together.
Contact our Tech Support Line for further information at...
Clutch Slave Cylinder
The clutch slave cylinder is typically located on the side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which pushes the slave cylinder shaft out to actuate the clutch...
Oil Drain Line
(Stainless Steel Braided)
Looking for a better oil drain line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any...
Street Tune-up Kit
A tune up kit that won't break the bank for your 2RZ or 3RZ from LC Engineering. Give your late 1998-2000 2RZ/3RZ an ignition tune up with our kit that includes four NGK spark plugs BKR5EYA and a set of NGK Spark Plug Wires. Not For...
Rod Bearing Set
(Coated)
Using CT-1 coated engine bearings is proven to reduce catastrophic engine failures dramatically.
Engines incorrectly plumbed or suffering from low or no oil pressure, cold starts, low or no flow have survived with little or no...
Oil Pump Cover
OEM oil pump cover for 3RZ. LC Engineering recommends replacing the cover anytime you have experienced debris going thru the motor or a catastrophic failure.
OEM Toyota Part #: 15115-75020
NOTE: For 2RZ/3RZ oil pump cover allen...
Pro Injection Plate Kit
Custom-made block plates and adapter plates needed to install our Pro Fuel Injection kits on 2RZ and 3RZ motors.
Plate Kit #1 Includes:
EGR block plates
MAP sensor mount plate
Water temp sensor (inline radiator hose...