Rod Bearing Set (0.50mm / +.020") These bearings for the 2RZ and 3RZ engines are factory replacement bearings. These factory replacement bearings offer the reliability and durability that you expect from LC Engineering. Contact our Tech Support...

DJM Complete Lowering Kit (3" Front & 3" Rear) A complete one box lowering kit for your Tacoma. 3″ in the front by repositioning your lower ball joint and then using new upper control arms to set your alignment back to factory specs and 3″ in the...

DJM Complete Lowering Kit (3" Front & 4" Rear) A complete one box lowering kit for your Tacoma. 3″ in the front by repositioning your lower ball joint and then using new upper control arms to set your alignment back to factory specs and 4″ in the rear...

DJM Complete Lowering Kit (3" Front & 4" Rear) Keep your factory strut and coils, use Calmax Upper and Lower Control arms and get a 3" fully alignable great riding drop. In the rear you install 4" all steel lowering blocks for the drop and a frame...

DJM Complete Lowering Kit For 05-14 Tacoma (3" Calmax control Arms / Rear Lowering Block Kit ) Tacoma's get the Calmax treatment too, quick and easy installation, great ride and performance, all Calmax trademarks! Keep your factory strut and coils, use...

DJM Lowering Kit (4" Rear) DJM rear kits are combinations of parts to lower trucks and suvs which do not fit the traditional descriptions like "flip kits", "hanger kits", etc. Often these rear kits are designed to work with lowering coil springs and...

Gauge Pillar (Double) (Unpainted-Gloss Black) Most older Toyota trucks had some pretty basic gauges (speedo, tach and fuel gauge). This doesn't work too well if you want to keep a close eye on the "heartbeat" of your engine. Most drivers want to see...

2005-2019 Toyota Tacoma 10″-12″ Lift Kit (BULLETPROOF) Searching for the ultimate lift kit system for your 2005+ Toyota Tacoma 10-12 Inch 2wd/4wd? Your search is over! Bulletproof Suspension Inc. has designed Toyota Tacoma 10-12 Inch Suspension Kit...

Complete 10-12" Toyota Tacoma Lift Kit (BULLETPROOF) Bulletproof Suspension Inc. has created a 2005-2019 Toyota Tacoma 10-12 Inch lift kit with the best leading design and engineering that can only come from Bulletproof Suspension Inc. All...

Triple Dog GT Platinum Tuner The GT Platinum is four products in one remarkable unit: a vehicle engine tuner, monitor, gauge, and diagnostic device all in a single unit. The exceptional GT transforms the utility of your vehicle by increasing...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...