Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 48mm long, heat treated and plated header mounting studs are stronger than stock. Kit Includes: (8)...

Brake Proportioning Valve Relocation Bracket Kit When you lift a Tacoma or Tundra, the Brake Proportioning Valve no longer senses loads properly and can cause a potentially dangerous braking situation. This kit relocates the Brake Proportioning Valve...

Safety Auto Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles...

GT25 Turbo Discharge Gasket (5 Bolt) Stainless Steel GT25 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

K&N Air Filter Oil (99-0516) K&N 99-0516 is a 12.25 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton fabric in K&N air filter elements providing a superior air...

K&N Air Filter Oil (99-0504) K&N 99-0504 is a 6.5 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton fabric in K&N air filter elements providing a superior air filtration...

Steel Weld-On Flange (Inlet / Outlet) If you are plumbing your wastegate into the exhaust pipe, these fitting are a good starting point. These Turbosmart wastegate flanges make installing your wastegate easy. These flanges are made out of the best...

Fuel Injector Rebuild Kit LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. Don't forget the cap end which is sold separately, there are two different styles depending on your year so make sure to...

Allen Head Hardware Kit (Oil Pump Cover) On your 2RZ/3RZ engine, replacing the hardware is recommended every time you remove your oil pump cover, Phillip's screws get worn out, and the heads are easily stripped if you don't use an impact screwdriver...

Oil Feed Fitting Kit LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. Kit Includes: (1) 12mm Banjo Bolt (1) - 4 AN Banjo Fitting (2) 12mm Copper Crush Washers Contact our...

1 3/4" Radiator Cap (Small) This Sankei OEM style Japan Radiator Pressure Cap that directly replaces the factory caps. The cap is 100% Stainless Steel and is a 13 pound cap or 0.9 kg/cm. Toyota used two styles of radiator caps the small one that...