Tacoma

GT25 Turbo Discharge Gasket (5 Bolt) Stainless Steel GT25 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

K&N Air Filter Oil (99-0516) K&N 99-0516 is a 12.25 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton fabric in K&N air filter elements providing a superior air...

K&N Air Filter Oil (99-0504) K&N 99-0504 is a 6.5 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton fabric in K&N air filter elements providing a superior air filtration...

Steel Weld-On Flange (Inlet / Outlet) If you are plumbing your wastegate into the exhaust pipe, these fitting are a good starting point. These Turbosmart wastegate flanges make installing your wastegate easy. These flanges are made out of the best...

1 3/4" Radiator Cap (Small) This Sankei OEM style Japan Radiator Pressure Cap that directly replaces the factory caps. The cap is 100% Stainless Steel and is a 13 pound cap or 0.9 kg/cm. Toyota used two styles of radiator caps the small one that...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

Blow Off Valve Weld On Fitting (You Choose Material) All our blow-off valves come supplied with aluminum adapters but if you are using a steel intake tube you will need the steel weld-on adapter, Aluminum weld-on adapters are designed to work with...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Water Pump Gasket (OEM) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...