Tundra

2-Bolt Stub Connector (You Choose Size) 2 1/4" Flange This is a 2-bolt collector reducer to allow you to fabricate your own exhaust after our header. Bolts to our street header and has 2.25" stainless steel tubing to weld or clamp to. 2 1/2" Flange This...

Merge Collector (You Choose Size) You've got that header all constructed, now you just need a collector to tie it all together. LC Engineering has already done the work for you, just pick the one for your application, slip it on, and weld it up! These...

Street Rod Bushing Set Any time you remove your connecting rods it is an excellent idea to change out the wrist pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause significant...

Intake Manifold Gasket Set (5VZ 1995-2004) OE Replacement intake manifold gasket set for 3.4L 5VZ engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images...

Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...

Oil Fitting (28BSPT to 1/8"NPT Female) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This is a steel fitting that will come in a silver or gold zinc finish. the 1/8 fittings may seem...

OEM Exhaust Hardware Kit This kit will contain (2) Bolts and (2) Springs needed for installing your exhaust back on at the collector. Kit Includes: (2) 90080-10291 Bolts (2) 90080-50392 Springs Contact our Tech Support Line for further...

Intake Valve (Black Nitride w/ Anti Friction Coating / 37.5mm 1mm Over) These valves are 1MM larger than stock, great for ported heads that need more flow through the valves. These stainless steel valves are lighter than the stock steel valves and...

Exhaust Valve (Black Nitride w/ Anti Friction Coating / 30.5mm - 1mm Over) These valves are 1MM larger than stock, great for ported heads that need more flow through the valves. These Black Nitride valves are lighter than the stock steel valves and...

K&N Filter Care Service Kit (Aerosol / 99-5000) K&N Recharger Kit 99-5000 is designed to service your K&N oiled cotton air filter when it gets dirty. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil. The 99-5000 Recharger...

K&N Sealing Grease (99-0704) K&N Sealing Grease 99-0704 provides an airtight fit around sealing surfaces on all types of air filter elements. It resists heat and will not melt or run off. K&N Sealing Grease is designed to ensure the filter stays sealed...

Rear Main Seal OEM replacement rear main seal. This will install on the big end of the crankshaft. If there is a large groove on the crank seal surface be sure to get our seal saver for trouble-free installation. For the Seal Saver, see Part #:...