-
Cylinder Head Bolt Set (Front of Cylinder Head) LC Engineering is striving to povide all those hard to find gaskets and or hardware for your build. If you don't see what you need on the site, please give us a call and we may be able to get it for you...$9.54 -
Shackle Spacer For Extra Flex Springs (Front / Rear) LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them. Contact our Tech...$9.52 -
LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...$9.51 -
Thermostat (160 Degree) There is really only one reason to run this thermostat. Race tracks that require vehicles to run water, no coolant, this is the thermostat you need. We would not recommend this for any vehicle running coolant. See our 180°...$9.27 -
OE Breather Hose (Front Of Valve Cover) OE Toyota hose comes off the valve cover and goes to intake manifold. Replaces OEM Toyota Part #: 12262-35030 NOTE: Not for carbureted applications. For carb applications, see Part #: 1072413 (1984 only), or...$9.10 -
Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...$9.00 -
Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...$8.78 -
OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...$8.60 -
CT-20 Turbo Stud Kit This stud kit was made to attach the CT-20 Turbo to the stock turbo manifold on your Toyota 22R-TE. If you find yourself needing to take apart a 20+ year old turbo setup, it is likely your old studs will be damaged or worn out. Why...$8.48 -
3mm Allen Wrench (Ball Head) This 3mm allen wrench is used mainly for our TPS screw upgrade kit. The ball end of the wrench allows off angle access to the TPS screws. This makes adjusting the TPS a lot easier if you are doing it in the vehicle. NOTE:...$8.44 -
Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...$8.19 -
Water Pump Gasket Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs with...$8.05
-
fast shipping
Speed Delivery