-
Shackle Bolt (Greasable) LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them. NOTE: Bolt is M18 x 150mm. For use with Trail Gear...$9.99 -
Transfer Case Dust Flange Dust shield for use with triple drilled output flange. Keeps rocks and other trail debris from damaging seals behind the output flange on your transfer case. This product should not be used in a manner that violates Federal...$9.99 -
1/4" Pipe to #6 JIC If you have an IFS steering box and want to tap your own box, this is the fitting you need to do it. This fitting has a male 1/4" pipe fitting on one end and male #6 JIC fitting on the other. NOTE: (2) fittings are required for...$9.99 -
90 Degree Elbow JIC Need some basic parts for your hydraulic ram steering? With hydraulic hose, high quality crimped connections and JIC 6 ends, these steering components will last. Optional Parts: 1/4" NPT Plug, see Part #: 2060078 Hydraulic...$9.99 -
Light Bar Tabs (Weld-On) Weld-On Light Tabs are CNC formed from 1/8" thick 1010 steel, coped for 1 1/2" or 1 3/4" O.D. tubing, and have a 1/2" sized bolt hole. These tabs also make great generic weld-on tabs for things like seats, seatbelts, or just...$9.99 -
Inner Axle Seal When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your tool box for trail side repairs. This product should...$9.99 -
Power Steering Reservoir Bracket This Rock Assault Reservoir Bracket bolts right to the back of our Rock Assault Reservoir and allows you to either weld the other side of the bracket to your cage (coped for 1 1/2" tubing) or simply butt weld it to a...$9.99 -
Reservoir Filter Bracket Our Rock Assault Reservoir Filter Bracket bolts right to the back of our Rock Assault Reservoir Filter Kit (into the pre-tapped holes) and allows you to either weld the other side of the bracket to your cage (coped for 1 1/2"...$9.99 -
Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...$9.99 -
Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...$9.85 -
Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...$9.59 -
Shackle Spacer For Extra Flex Springs (Front / Rear) LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them. Contact our Tech...$9.52
-
fast shipping
Speed Delivery