67″ Rock Sliders
Rock Sliders are a great way of protecting the rocker panels of your 84-88 extra-cab pickup. Heavy duty construction can take a pounding from the rocks while keeping body damage to a minimum. Strong enough to take the entire weight of the truck. A high-lift jack can be used anywhere along its length for repositioning of rig or axle servicing. Made from 1 3/4" X .120" round DOM tubing. Bars come with the outer section welded but the legs are not attached. Legs are pre-notched and can be cut to length to allow for different mounting positions. Unpainted steel finish is ready for spray paint or powder-coating.
NOTE: For the Rock Slider Mounting Kit (6 Leg), see Part #: 3032484.
This product should not be used in a manner that violates Federal EPA Laws.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
| Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501. |
by Trail-Gear
- 1984-1988 Pickups (Extended Cab)
To open a printable PDF version of this instruction CLICK HERE
Installation:
-
1. Using jack stands, place sliders at desired position on vehicle. Center bars front to rear between wheel openings. Tilt bars up approximately 15 degrees but make sure that both doors will open without hitting the bars.
2. Cut legs to fit between frame and bars. Cut front leg tube on each side at an angle to match frame. Center and rear legs can all be cut straight.
3. If mounting bars up close to body, maintain 1/4" gap between body and bars to prevent vibrations. Mark body pinch weld with marker for cutting as necessary.
4. Tack weld notched end of legs to sliders. Remove sliders and fully weld legs to bars.
5. Cut half moon shaped sections from pinch weld to clear legs.
6. Place fully welded bars onto stands. Weld bars directly to frame. Make sure to maintain 1/4" gap between body and bars.
7. Cover lower body with cardboard. Clean bars with degreasing fluid. Paint and primer as desired.
Pinch Weld Cutout
Installed
