STEERING

Power Steering Reservoir When installing a high flow pump such as the one listed above, it is important to use a larger reservoir to provide enough fluid when the system needs it. The stock reservoir is fine for the stock pump but is not adequate for...

Steering Pump Kit Hoses This kit contains one high pressure and three low pressure power steering lines. These lines are used to connect the pump, steering box and cooler together. The two hoses that go from the steering ram to the steering box are not...

Power Steering Fluid Cooler If you're running a high volume/pressure pump your system is generating much more heat then the stock system. Fluid overheating can cause damage to steering pump and steering box. Installing an oil cooler in front of the...

by Trail-Gear

OE Idler Arm IFS Time for replacing Idler Arm? LC Engineering offers the best option available in the market. We all know that if one of your suspension-steering components is not working properly, it will eventually affect your tire alignment or it...

Flat Pitman Arm Solid one piece design. Features FJ80 tapered hole. Extra strong and wide, one piece, forged design. Ideal for use with crossover steering. Your choice of flat arm or drop arm.  The flat arm has no drop.  The drop arm has same...

Stock Drop Pitman Arm This Stock Drop Pitman Arm is a solid one piece, forged design, and features a FJ80 tapered hole. For use with crossover steering and features the same drop as the factory pitman arm. This product should not be used in a manner...

Trail Safe Knuckle Ball Wiper Seal Tired of wiping big clumps of dirty sandy grease off of your knuckle balls after every trip? So are we. We asked our engineering department to look at the problems with the OEM design along with what was currently...

Lower Knuckle Caps (Solid Axle) These stock replacement caps fit on the bottom of 79-85 Toyota solid axle knuckles. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information...

Crossover Steering Drag Link (You Choose Size) These heavy duty drag links are made from 1.25" x .250" wall DOM tubing. Precision tapped. Left side thread mark. Powder coat black finish. When installing a Rock Assault Front Axle Housing and using a hi...

Tie Rod (Choose Your Length) Trail Gear's heavy duty tie rods are made from 1.25" x .250" wall DOM tubing, precision tapped with a left side thread mark. Each rod is test fitted to ensure rod ends thread in with correct fit. Powder coat black finish...

Steering Columns 3 1/4 Inches: This steering column will allow you to use your existing Toyota steering linkage without having to buy a coupler and then cut and weld on your steering shaft. This steering column measures 3 1/4 inches from the base of...