SUSPENSION

Panhard Link Tubing (Front 3-Link) This drag link is made from .250" wall DOM 1.25" tubing, precision tapped, and features a left side thread mark. Each rod is test fitted to ensure that rod ends thread in with correct fit. This product should not be...

Upper Link Frame Bracket (Front 3-Link) This is the Upper Link Frame Bracket that attaches to the passenger side of the frame. The link goes on the inside of the frame. This product should not be used in a manner that violates Federal EPA Laws...

Trail-Link Three Front 3-Link Bracket (Panhard / Axle) Built out of 3/16" Plate Steel, the Trail-Gear Link Mounts are a perfect solution for upgrading the factory brackets. They also make it easy to swap suspension from leaf springs to a 3-Link or...

Front 3-Link Panhard Bracket (Rock Assault) Our Rock Assault™ Front Three Link Pan Hard Bracket will allow you to use your current Trail-Link Three™ Front 3-Link Kit with your new Rock Assault™ Front Axle Housing. If you are ordering the Trail-Link...

Front 3-Link Lower Link Axle Bracket (You Choose Side) Built out of 3/16" Plate Steel, the Trail-Gear Link Mounts are a perfect solution for upgrading the factory brackets. They also make it easy to swap suspension from leaf springs to a 3-Link or...

Body Mount Bushings These suspension bushings replace distorted and worn-out original rubber mounts to maintain truck cab to bed alignment. Original rubber mounts are so soft they often crack, distort, and crush so badly they often fall off! And...

DJM Lowering Steel Block Kit (3" Rear) The hot set up for the rear of small and mid-size pick ups plus suv's where the axle is on top of the leaf spring is the good old lowering block kits. All kits have new U-bolts, nuts and washers! Contact our...

Differential Drop Spacer Kit (w/ Sway Bar) One thing often overlooked when lifting an IFS truck is the differential and axles. Most larger lifts will drop the differential down with brackets, but with smaller lifts (torsion bar lift, ball joint spacer...

Johnny Joint 1.25" Rod End (Right Threaded) Forged Johnny Joint® rod ends feature forged steel construction, a 1 1/4"-12 right hand threaded shank and come fully assembled with our standard Johnny Joint internals (2.625" wide ball center with a...

Control Arm Bushings These bushings maintain proper alignment under extreme conditions on and off -road and during competition. Helps provide quicker steering response and greater vehicle control. Whatever your demands, proper alignment (caster and...

Control Arm Bushings These bushings maintain proper alignment under extreme conditions on and off -road and during competition. Helps provide quicker steering response and greater vehicle control. Whatever your demands, proper alignment (caster and...

Rear Leaf Spring Bushings For high-performance applications, the combination of heavy duty or performance leaf springs and performance polyurethane spring bushings deliver the maximum benefit. For lighter-duty leaf springs they add a higher degree of...