1974

K&N Sealing Grease (99-0704) K&N Sealing Grease 99-0704 provides an airtight fit around sealing surfaces on all types of air filter elements. It resists heat and will not melt or run off. K&N Sealing Grease is designed to ensure the filter stays sealed...

Pinion Head Bearing The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for these Celica rear ends. This is the bearing that rides on the...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 1.25 x 48mm long, heat-treated plated header mounting studs are stronger than stock. Works with a stock...

Carrier Bearing (Pinion Side) Carrier bearing for the 6.7" Celica differential. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for...

Rear Main Seal High-quality silicone seals with a double lip for improved sealing. If you have a big groove worn in the crankshaft seal surface, you'll need one of our seal savers for trouble-free installation without leaks. Be sure to wipe some engine...

Merge Collector (3-1 1/2″ into 1-2 ¼″) You've got that header all constructed, now you just need a collector to tie it all together. LC Engineering has already done the work for you, just pick the one for your application, slip it on, and weld it...

2" ID Silicone Elbow (90º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

2.75" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for Turbo Intercooler or Air! Dress up your engine compartment by replacing your air lines with the highest quality silicone hose available! Full vacuum through the...

Shaft Tail Bearing (Rear Pinion) This bearing is for the end of the pinion gear, closest to the splines. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with...

O-Ring & Isolator Kit O-Ring and Isolator set for Weber sidedraft carburetors. Kit Contains: (2) Plastic O-ring plates (4) O-Rings (4) Springs NOTE: Each kit will only service (1) carburetor, make sure you order (2). Contact our Tech...

Exhaust Valve (Stainless Steel / 40mm +2mm) These are the same 40mm exhaust valves we use in our stage 5 cylinder heads. 40mm exhaust valves are designed for use in heavily ported high-performance applications only. They must be used with matching...

Intake Valve (Stainless Steel / 48mm +2mm) These are the same 48mm intake valves we use in our stage 5 cylinder heads. 48mm intake valves are designed for use in heavily ported high-performance applications only. It must be used with matching seats...