Manual Choke Kit (w/ Cable) If you are looking to convert your electric choke Weber 32/36 or 38 carbs to a manual choke application, look no further. Kit Includes: Cable Bracket Hardware Contact our Tech Support Line for further information...

U Bend (6″ Radius) Use these 3" U-Bends for building your own headers or replacing a bent or damaged tube. NOTE: Size listed is the outside diameter. Constructed of mild steel. Contact our Tech Support Line for further information at...

Clutch Master Cylinder The classic symptom of a worn throw-out bearing is a whirring, growling, or chirping sound when applying the clutch pedal, which goes away after releasing the pedal. Premature wear of the throw-out bearing can occur when there is...

Clutch Slave Cylinder The clutch slave cylinder is typically located on the side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which pushes the slave cylinder shaft out to actuate the clutch...

3.00" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

2.32" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

E-Boost Street Boost Controller (40 PSI) Racing technology for the street E-Boost street is an electronic boost controller aimed at the street performance market. It features many boost control capabilities found on its big brother the e-Boost2,...

Oil Feed Line (Stainless Steel Braided) Looking for a better oil feed line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any application...

Oil Drain Line (Stainless Steel Braided) Looking for a better oil drain line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...

Oil Pan Hardware Kit (Silicone Seal) This oil pan hardware kit includes all the bolts and washers needed to install your oil pan and pick up tube. This hardware kit is designed to work with silicone seal pans only. This kit will not work with gasket...