Accelerator Pump Jet Replacement accelerator pump jet for the Weber DCOE (Sidedraft) carburetor. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not...

Weld-On Oxygen Sensor Flange (2-Bolt Flange Style) This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors. Contact our Tech Support Line for further...

OE Style Oil Filter This is a factory replacement oil filter. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed. Please...

Rubber Tailpipe Hanger (2-Hole) Factory replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

1/4" 90 Degree Fitting (Push-Lok to -4AN Swivel) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 90 degree fitting is used for the oil feed line at the turbo or block. Perfect for...

2" Silicone Coupler Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following temperature range:...

Pro Bronze Valve Guide Valve Guides are made of the highest quality manganese bronze material available. This provides additional clearance between retainer and seal for increased valve lift. Valve Guides provide excellent stability so they can be run...

Thermostat (180 Degree) Reduced engine temperatures add life to your engine and provide a denser air/fuel mixture which helps produce more horsepower. Consistent control of the engine temperature allows an engine to operate at its peak efficiency, no...

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...

Thermostat (160 Degree) There is really only one reason to run this thermostat. Race tracks that require vehicles to run water, no coolant, this is the thermostat you need. We would not recommend this for any vehicle running coolant. See our 180°...

T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...