Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...

Manual Choke Kit (w/ Cable) If you are looking to convert your electric choke Weber 32/36 or 38 carbs to a manual choke application, look no further. Kit Includes: Cable Bracket Hardware Contact our Tech Support Line for further information...

Rear Outer Axle Seal (Rubber) Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support...

Oxygen Sensor Install Kit (2-Bolt Style) This kit contains everything you need to install the factory 2-bolt O2 sensor into your custom exhaust. It allows you to weld in the O2 sensor wherever you want it in the exhaust. Kit Includes: (2) Studs and...

2-Bolt Flange (2 1/4") Steel flange designed for connecting to our header collectors. This is perfect if you are fabricating your own exhaust from the header back. 3/8" thick, for 2-1/4" exhaust tubing. Contact our Tech Support Line for further...

Union Bolt (Fuel Rail) LC Engineering offers this M14 x 1.25 replacement Union Bolt that threads into the front of your fuel rail. This also replaces the fuel damper on early 22RE fuel rails. Contact our Tech Support Line for further information...

Rubber Tailpipe Hanger (3-Hole) Factory 3 Hole replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent...

Holley Power Valve (3.5″) These power valves are an important component in the power enrichment circuit of Holley's performance carburetors. They operate by using engine vacuum to control their opening and closing rate. When they open, additional fuel...