Solid Axle Knuckle Service Kit (w/ Wheel Bearings) When was the last time you serviced your knuckles? This service kit contains all standard replacement parts including gaskets, felts, seals, washers and shims. Kit includes inner axle seals and outer...

Knuckle Felt Protector Kit (Rock-Ring) We have had a lot of people tell us they don't like the stock inner felt plates because they are so thin and are easily damaged in the rocks. Well check out this trick solution... super heavy duty rings made from...

Steering Stabilizer Kit (9.55" Stroke) To reduce steering vibrations at higher speeds, a steering stabilizer can be very helpful. We offer a stabilizer kit that attaches above the drag link. One end welds to the passenger side frame rail and the other...

1650Psi Power Steering Pump (w/ Pulley) Trail-Gear’s new Power Flow 1650 psi pump has been designed and engineered to provide ultimate performance. The body of the pump is constructed of steel to increase reliability and decrease wear. It is...

Power Steering Pump Bracket Kit (Rock Assault) This pump bracket is designed to adapt our "TC" style power steering pumps to your 75-95 Toyota 20R/22R/RE/RET engine. This bracket will utilize the stock idler pulley for the power steering belt. NOTE:...

Long Travel Driveline (Matsuba U Joint) We are pleased to announce the release of a new and improved heavy duty drive line. The heavy duty driveline splines are 42% larger than our old design and the spline section is nylon-coated to prolong many years...

Turbo Insulating Kit This insulating kit is designed to fit most turbos. Reduces turbo lag and keeps under hood temperatures cooler. Comes complete with easy-to-follow instructions and all of the materials necessary to complete the job of insulating...

Valve Cover Hardware Kit Valve cover hardware kit includes (4) studs and (4) chrome acorn nuts, for the 20R/22R/RE (all years). We also use the studs in this kit for mounting 1" spacers to adapters, nuts are not used. This product should not be used...

T3 Inlet Turbo Flange (4-Bolt) This flange is constructed of 1/2" steel and has threaded holes for easy installation of your turbo. It is designed for any turbo that uses a T3 style inlet flange. Don't see what you need? Just call our Technical Dept...

Garret T3 Exhaust Discharge Flange (5 Bolt) All of LC Engineering's flanges are laser cut then finished machined on the CNC to ensure exact tolerances and fit. This 5-bolt flange fits standard 5-bolt T3/T4 turbo exhaust housings, including the turbos...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...

Weld-On Oxygen Sensor Flange (2-Bolt Flange Style) This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors. Contact our Tech Support Line for further...