1980

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...

OEM Radiator Fan Shroud Clip (1979-1998 4Runner/Pickup/Celica/Tacoma/T100) OEM Radiator Fan Shroud Clip. OEM Toyota Part #: 90468-06013 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...

Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...

Rear Frame Shackle Bushings For high-performance applications, the combination of heavy duty or performance leaf springs and performance polyurethane spring bushings deliver the maximum benefit. For lighter-duty leaf springs they add a higher degree of...

Fuel Pump Spacer (Mechanical Fuel Pump) This black plastic spacer installs between the manual fuel pump and the cylinder head. The spacer is needed to properly mount the fuel pump to get the correct stroke off the camshaft. Contact our Tech...

Oxygen Sensor Install Kit (2-Bolt Style) This kit contains everything you need to install the factory 2-bolt O2 sensor into your custom exhaust. It allows you to weld in the O2 sensor wherever you want it in the exhaust. Kit Includes: (2) Studs and...

2-Bolt Flange (2 1/4") Steel flange designed for connecting to our header collectors. This is perfect if you are fabricating your own exhaust from the header back. 3/8" thick, for 2-1/4" exhaust tubing. Contact our Tech Support Line for further...

Union Bolt (Fuel Rail) LC Engineering offers this M14 x 1.25 replacement Union Bolt that threads into the front of your fuel rail. This also replaces the fuel damper on early 22RE fuel rails. Contact our Tech Support Line for further information...

Rear Outer Axle Seal (Rubber) Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support...