1981

Matsuba Drive Shaft U-Joints (Stock Replacement) OEM Replacement U-Joint. We have tested these joints to 3700 ft-lbs of torque before failure. Includes four install clips and Zerk grease fitting. NOTE: Does not fit CV side of driveline. Contact...

Hastings Street Piston Ring Set (93.00mm / +.040″) LC Engineering's street rings are custom packaged by Hastings to our requirements. Hastings piston rings are built with cast iron, barrel face top compression rings. They have conventional cast iron...

Street Tune-up Kit (w/ Plug Wires) A tune up kit that won't break the bank, for your 1980 to1992 20R/22R/RE from LC Engineering. Included are (4) NGK Spark Plugs BKR5EYA, a set of Denso Spark Plug Wires (Black), a Street Distributor Cap (black), and a...

Foam Sock Filters These filter socks fit all sidedraft carburetor air horns. Kit Includes: (2) Filters (2) Zip ties Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Carburetor Jet Kit (High Elevation) This kit is used to make the air/fuel mixture leaner. A properly jetted carburetor, that worked well a couple of years ago, may have lost some of its performance due to today's leaner fuels. Some symptoms of a lean...

Oil Drain Line (Stainless Steel Braided) Looking for a better oil drain line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any...

Hastings Street Piston Ring Set (92.00mm / Standard) LC Engineering's street rings are custom packaged by Hastings to our requirements. Hastings piston rings are built with cast iron, barrel face top compression rings. They have conventional cast iron...

26" Extended Brake Line (Front / Female - Female) These steel braided brake lines are 26" long and are DOT approved. Front lines use factory mounting clips so there is no need to modify the factory clips in any way. Specifications: Size:...

26" Extended Brake Line (Rear / Female - Male) These steel braided brake lines are 26" long and are DOT approved. Front lines use factory mounting clips so there is no need to modify the factory clips in any way. Specifications: Size...

Weber 32/36 Jet Kit (High Elevation / Fuel Economy) This kit is used to lean the air/fuel mixture. A properly jetted carburetor that worked well a couple of years ago, may have lost some of its performance due to today's leaner fuels. Some symptoms of...

Air Cleaner Adapter Kit (Weber 32/36/38 Carb to K&N Air Filter) LC Engineering manufactures this adapter from billet 6061-T6 aluminum. This will allow you to use an aftermarket air cleaner on your Weber 32/36 or 38 carburetor. The adapter will go...

Spindle Stud Kit When assembling your spindles gaskets does it feel like your all thumbs? This kit contains (16) studs and flanged nuts. With studs installed it's easier to install the spindle gaskets. Gaskets are placed on the studs one at a time,...