1981

Hall Sensor Mount This bracket is needed if you are installing our Pro Fuel Injection Systems on a 22RE engine. This mount will locate the Hall sensor in the right location for both the stock pulley and the LC Engineering underdrive pulley. This...

Engine Rebuild Oil Galley Plug Kit Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off after cleaning. LC Engineering can supply you with all these hard to find plugs. Most engines have some sort of...

K&N Filter Care Service Kit (Aerosol / 99-5000) K&N Recharger Kit 99-5000 is designed to service your K&N oiled cotton air filter when it gets dirty. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil. The 99-5000 Recharger...

K&N Sealing Grease (99-0704) K&N Sealing Grease 99-0704 provides an airtight fit around sealing surfaces on all types of air filter elements. It resists heat and will not melt or run off. K&N Sealing Grease is designed to ensure the filter stays sealed...

Safety Auto Rod Bearing Set When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end.These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

Front Sway Bar Bushings (19mm) Improved handling, low cost, and easy installation are just some of the reasons these components are so popular! These sway bar bushings offer the greatest improvement in performance handling on trucks and sport utility...

Front Sway Bar Bushings (23mm) Improved handling, low cost, and easy installation are just some of the reasons these components are so popular! These sway bar bushings offer the greatest improvement in performance handling on trucks and sport utility...

Pinion Head Bearing The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for these Celica rear ends. This is the bearing that rides on the...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 1.25 x 48mm long, heat-treated plated header mounting studs are stronger than stock. Works with a stock...

Carrier Bearing (Pinion Side) Carrier bearing for the 6.7" Celica differential. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for...

Rear Main Seal High-quality silicone seals with a double lip for improved sealing. If you have a big groove worn in the crankshaft seal surface, you'll need one of our seal savers for trouble-free installation without leaks. Be sure to wipe some engine...

Fuel Pump Eccentric When eliminating the fuel pump eccentric from the stock distributor, you will need this spacer to bring the drive gear back into alignment. This is an OEM core unit processed by LC Engineering. Only used on 22R when eccentric is...