1982

1 3/4" Radiator Cap (Small) This Sankei OEM style Japan Radiator Pressure Cap that directly replaces the factory caps. The cap is 100% Stainless Steel and is a 13 pound cap or 0.9 kg/cm. Toyota used two styles of radiator caps the small one that...

Water Block Plate (Under EFI Manifold) This water block off plate goes under the intake manifold on fuel-injected 22RE engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

PCV Relocation Kit If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

Hose Clamp for Radiator Inlet LC Engineering is now offering an OEM hose clamp for your radiator inlet. No part is to be over-looked now... No part to small. Don't see what you need? Call our sales team, they might be able to track it down for you...

Street Rod Bushing Any time you remove your connecting rods it is an excellent idea to change out the pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause major engine damage. The...

Outer Tie Rod We all know that if one of your suspension-steering components is not working properly, it will eventually affect your tire alignment or it will make it impossible to align your vehicle. LC Engineering offers only the best replacements...

Exhaust Valve (Stock Length) (Stainless Steel / 37.5mm) In 2019 LC Engineering revised it's Stainless Steel Exhaust Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

Blow Off Valve Weld On Fitting (You Choose Material) All our blow-off valves come supplied with aluminum adapters but if you are using a steel intake tube you will need the steel weld-on adapter, Aluminum weld-on adapters are designed to work with...

Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles to come. We...