1982

2" Silicone Coupler Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following temperature range:...

Plug Wire Separator Kit (8.5mm Pro Wires) These composite separators are held together with Allen head screws which are mounted flush within the loom. These separators are designed specifically to work with our billet wire loom and LC Pro Wires. They...

OE Style Oil Filter This is a factory replacement oil filter. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed. Please...

Rubber Tailpipe Hanger (2-Hole) Factory replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

1/4" 90 Degree Fitting (Push-Lok to -4AN Swivel) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 90 degree fitting is used for the oil feed line at the turbo or block. Perfect for...

Wristpin Locks (.866" Diameter) This set of wrist pin locks is what is required to hold your connecting rod wrist pins in place. These are essential pieces that should not be overlooked. Always replace wrist pin locks when refreshing your motor...

Trail Gear Brake Line Clip & Mount (Rear Line Only) This brake line mount kit is designed to fit Trail Gear extended length brake lines. If you've added a little (or a lot) extra ground clearance and suspension travel, you probably have added some...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

Inner Axle Seal When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your tool box for trail side repairs. This product should...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...