1984

OE Breather Hose (Front Of Valve Cover) OE Toyota hose comes off the valve cover and goes to intake manifold. Replaces OEM Toyota Part #: 12262-35030 NOTE: Not for carbureted applications. For carb applications, see Part #: 1072413 (1984 only), or...

Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...

Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...

Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...

Exhaust Valve (Steel / Stock Size 36.5mm) If you're looking for replacement valves for your Toyota 22R/RE/RET engine, then these high-strength steel OE type replacement valves are just right for you. These valves utilize the factory size valve seats...

OEM PCV Valve (Steel) A Factory replacement OEM PCV valve with steel design straight up outlet. Use this PCV to replace the stock one that has the molded rubber hose. Don't forget the new PCV grommet, see Part #: 1024084 or the new hose from Toyota...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler, therefore making more power. This is the ultimate...

Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...

Valve Adjuster (OEM) New valve adjusters and adjuster nuts can play a considerable role when rebuilding your cylinder head, adding a new camshaft or other new valve train components. A small investment to keep your motor running strong. OEM Toyota...

OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...