Fuel Pump Relay Fuel pump Relay for Pro Fuel Injection Kits. Required for the computer to turn on the electric fuel pump. Much easier than having an additional switch on the dashboard! Contact our Tech Support Line for further information at...

Knock Sensor Upgrade This is for the upgrade for the newest Pro Fuel Kits using the SDS computer. The upgrade will come with the Knock Sensor and adapter. Knock control allows the ECU to retard the ignition timing automatically if knocking is detected...

Throttle Position Sensor Plug (w/ Wires) As time marches on Toyota will, little by little, discontinue parts it carries for the 22R/22RE powered trucks. We are here working hard to step in and make sure that the parts you need are still out there to...

Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...

Fuel Injector Caps These black injector caps fit Type C & Turbo model injectors only. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type E or F caps, see Part #:...

Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O-Rings for OEM Toyota 2RZ and 3RZ fuel injectors. Located on in the cylinder head for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

Pro Air Fuel Tuning Module (Mixture Meter) The Pro Tuning Module gives you the ability to adjust the fuel curve in your 22RE. If your Air Fuel Ratio shows lean, turn the tuning module to a richer setting, it's just that simple. Contact our Tech...

Oxygen Sensor (Heated 4 Wire) This is considered a universal replacement for the 4-wire heated O2 sensor as well as a stock replacement. This would be an upgrade to the one wire but will require running power and ground to the sensor. Constructed from...

Garrett T3 / T4 Hybrid (Pro Turbo / Low Boost) The Garrett T3/T4 Hybrid turbo is the best of both worlds! The low inertia and fast boost response of the lightweight T3 turbine wheel combined with the high airflow characteristics of the T4 compressor...