GT25R Turbo Inlet Gasket (Metal) A Stainless Steel inlet gasket for the GT25 turbos that we use in our CT20 conversion kit. For between the turbo manifold and the GT25 turbo or our adaptor and the GT25. Contact our Tech Support Line for further...

Fuel Injector Caps These black injector caps fit Type C & Turbo model injectors only. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type E or F caps, see Part #:...

Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Oil Pan Hardware Kit (Silicone Seal) This oil pan hardware kit includes all the bolts and washers needed to install your oil pan and pick up tube. This hardware kit is designed to work with silicone seal pans only. This kit will not work with gasket...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Rear Inner Axle Seal Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support Line for...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

8" Oil Dipstick Tube Bracket (Shorty Style) OEM part direct from Toyota! Don't look any further for a new replacement dipstick Tube Bracket to replace your old one. This is the shorty style dipstick tube bracket found on most 22R and 22RE applications...

OEM Shifter Boot (Manual Transmission) It's common for the factory shift lever boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transmission shifter then into the transmission. This simple rubber...

Gasket Set (Weber Adapter) Avoid or fix annoying vacuum leaks by replacing the gaskets between the plates the Weber 32/36 and 38 carb adapter. Over time gaskets become brittle and break. We recommend these gaskets to be replaced any time the adapter is...

Pro Chromoly Retainer (Dual Spring) For hot street motors or moderate race motors, the Chromoly retainers fit the bill nicely. Use these with our dual valve springs for proper valvetrain control up to 6,000 RPM. These retainers are substantially...

Rear Pinion Seal The pinion seal will need to be replaced any time the gear ratios are changed. This pinion seal is a high quality oil seal that will offer you years of service. The 6.7" Toyota differential is becoming increasingly more difficult to...