EFI Intake Bolt (Long) M8-1.25 x 95mm Socket Head Cap Screw for use on EFI intake. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Base Gasket Fix or prevent pesky vacuum leaks at the carburetor base by replacing the gasket between your stock 22R Aisin carb and the intake manifold. Genuine Toyota quality gasket. Contact our Tech Support Line for further information at...

Throttle Body Gasket (Paper "O" Shape) Throttle body gaskets can be a source of hard-to-find vacuum leaks if the throttle body is removed or disrupted. Any time you remove your throttle body, you should replace the gasket while you're at it. On the 3.4...

Throttle Body Gasket Throttle body gaskets can be a source of hard-to-find vacuum leaks if the throttle body is removed or disrupted. Any time you remove your throttle body, you should replace the gasket while you're at it. This is a stock replacement...

Dowel Pin (Aligns Cylinder Head To Block) When installing a new head on your 20R, 22R or 22RE, these dowel pins can make head gasket alignment much easier. by installing these in the block, the gasket and cylinder head all fit snugly and perfectly...

OEM Vent Hose Spring Clamp Need to connect the vent hose and secure it properly? Simply get these spring clips into place, and release. Nothing makes a job easier than having proper fitting replacement parts. Look no further, LC has you covered. OEM...

Holley Base Gasket Avoid annoying vacuum leaks and replace the gasket any time you remove the carburetor from the intake. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Idle Jet Holder O-Ring These O-Rings seal the idle jet holder to the main carburetor housing. O-Rings can become brittle with age and cause annoying (and dangerous) fuel leaks. NOTE: O-Rings sold individually. Contact our Tech Support Line for...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...

Exhaust Collector Gasket (2 1/4" / 3 Bolt) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive seal. 3-bolt...

Large Oil Galley Plug (3/8"-19 BSPT) Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off. You will need two, one goes in the front of the block, and one goes in the rear of the block. LC Engineering...

Thermostat Housing Gasket (Paper / Flat) Any time you replace the thermostat or remove the housing, you should replace the gasket to avoid future leaks. This gasket is a paper gasket that offers an excellent seal for your thermostat housing...