T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...

LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -8AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

OE Breather Hose (Front Of Valve Cover) OE Toyota hose comes off the valve cover and goes to intake manifold. Replaces OEM Toyota Part #: 12262-35030 NOTE: Not for carbureted applications. For carb applications, see Part #: 1072413 (1984 only), or...

Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...

Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...

Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...

Exhaust Valve (Steel / Stock Size 36.5mm) If you're looking for replacement valves for your Toyota 22R/RE/RET engine, then these high-strength steel OE type replacement valves are just right for you. These valves utilize the factory size valve seats...

OEM PCV Valve (Steel) A Factory replacement OEM PCV valve with steel design straight up outlet. Use this PCV to replace the stock one that has the molded rubber hose. Don't forget the new PCV grommet, see Part #: 1024084 or the new hose from Toyota...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

CT-20 Turbo Stud Kit This stud kit was made to attach the CT-20 Turbo to the stock turbo manifold on your Toyota 22R-TE. If you find yourself needing to take apart a 20+ year old turbo setup, it is likely your old studs will be damaged or worn out. Why...