1987

Turbo Discharge Gasket (CT20) This is a replacement for the OEM turbo discharge gasket for 22RET engines with the CT20 Turbo. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

K&N Filter Care Service Kit (Aerosol / 99-5000) K&N Recharger Kit 99-5000 is designed to service your K&N oiled cotton air filter when it gets dirty. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil. The 99-5000 Recharger...

K&N Sealing Grease (99-0704) K&N Sealing Grease 99-0704 provides an airtight fit around sealing surfaces on all types of air filter elements. It resists heat and will not melt or run off. K&N Sealing Grease is designed to ensure the filter stays sealed...

Safety Auto Rod Bearing Set When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end.These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

Front Sway Bar Bushings (19mm) Improved handling, low cost, and easy installation are just some of the reasons these components are so popular! These sway bar bushings offer the greatest improvement in performance handling on trucks and sport utility...

Front Sway Bar Bushings (23mm) Improved handling, low cost, and easy installation are just some of the reasons these components are so popular! These sway bar bushings offer the greatest improvement in performance handling on trucks and sport utility...

PCV Hose This is the OEM 22RE PCV hose for the PCV Valve on top of the valve cover. OEM Toyota Part #: 12261-35011 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...

Breather Hose (Front Of Valve Cover) OEM Toyota hose comes off the valve cover and goes to intake manifold. OEM Toyota Part #: 12262-35030 NOTE: Not for carbureted applications. For carb applications, see Part #: 1072413 (1984 only), or Part #: ...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 1.25 x 48mm long, heat-treated plated header mounting studs are stronger than stock. Works with a stock...

Header Stud Set Replacing your Turbo manifold? It is a good idea to replace your studs too! LC Engineering offers nothing but the best quality components around. The factory exhaust manifold studs have a shoulder in the center that can interfere with...

Rear Main Seal High-quality silicone seals with a double lip for improved sealing. If you have a big groove worn in the crankshaft seal surface, you'll need one of our seal savers for trouble-free installation without leaks. Be sure to wipe some engine...

A/C Power Steering Idler Pulley You might need to replace A/C power steering idler pulley for your 1985-1995 22R/RE engine if the existing pulley is worn out, damaged, or making excessive noise. This pulley is crucial for maintaining proper tension on...