1987

Street Rod Bushing Any time you remove your connecting rods it is an excellent idea to change out the pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause major engine damage. The...

Outer Tie Rod We all know that if one of your suspension-steering components is not working properly, it will eventually affect your tire alignment or it will make it impossible to align your vehicle. LC Engineering offers only the best replacements...

Exhaust Valve (Stock Length) (Stainless Steel / 37.5mm) In 2019 LC Engineering revised it's Stainless Steel Exhaust Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

Blow Off Valve Weld On Fitting (You Choose Material) All our blow-off valves come supplied with aluminum adapters but if you are using a steel intake tube you will need the steel weld-on adapter, Aluminum weld-on adapters are designed to work with...

Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

Intake Valve (Stock Length) (Stainless Steel / 45.5mm) In 2019 LC Engineering revised it's Stainless Steel Intake Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

OEM "J" Bolt (Battery Hold Down) OEM Toyota "J" bolt for battery hold down bracket. OEM Toyota Part #: 74451-89103 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley without alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...