1988

Idle Jet Holder O-Ring These O-Rings seal the idle jet holder to the main carburetor housing. O-Rings can become brittle with age and cause annoying (and dangerous) fuel leaks. NOTE: O-Rings sold individually. Contact our Tech Support Line for...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...

Valve Keeper It is recommended to use hardened valve keepers every time you rebuild your engine. LC Engineering carries hardened valve keepers for all 3VZ valves using stock Toyota retainers or Street Performer retainers. A must for any high RPM...

Exhaust Collector Gasket (2 1/4" / 3 Bolt) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive seal. 3-bolt...

Large Oil Galley Plug (3/8"-19 BSPT) Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off. You will need two, one goes in the front of the block, and one goes in the rear of the block. LC Engineering...

Thermostat Housing Gasket (Paper / Flat) Any time you replace the thermostat or remove the housing, you should replace the gasket to avoid future leaks. This gasket is a paper gasket that offers an excellent seal for your thermostat housing...

T-stat Housing Adapter O-Ring (Offenhauser Manifolds) If you are running an Offenhauser intake manifold you are most likely using our thermostat housing adapter with a late style water neck. The adapter has its own O-ring (other than the one around the...

Oxygen Sensor Gasket (2-Bolt Style) This gasket is a direct replacement for 2-bolt O2 sensors. If you have to replace the O2 sensor, you should replace the gasket as well to avoid pesky exhaust leaks. Contact our Tech Support Line for further...

Medium Oil Galley Plug (1/4"-19 BSPT) Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off. You will need four of these for the crankshaft and one for the inside of the block under the oil filter...

Spring Seat Shim (.015″ / .030" / .060") Hardened Valve Spring Shims for Pro and Street Performer Valve Springs. When installing new valve springs, it is very crucial to get the springs all set up equally for proper valvetrain geometry and longevity...

DCOE Jet Cover Gasket LC Engineering offers only genuine Weber/Redline products. Don't get fooled by cheap imitations out there, they will never perform as good as genuine Weber equipment. Contact our Tech Support Line for further information at...

Oil Drain Plug Gasket (Small) This is the oil drain plug gasket for LC Engineering's small oil drain plug Part # : 1013117. OEM Toyota Part #: 90430-12031 Contact our Tech Support Line for further information at 928-575-2174. Note:...