1990

Weber Downdraft Air Correction Jet (Range: 1.35-1.80) Weber calibrated air correction jets are a legendary component that meters air to the emulsion tube well. Weber is without question the most popular for performance applications. In good tune, the...

Weber Air Correction Jet (Range: 1.85-2.20) Weber calibrated air correction jets are a legendary component that meters air to the emulsion tube well. Weber is without question the most popular for performance applications. In good tune, the results are...

Heater Tube O-Ring (Under EFI Manifold) The O-ring seals the heater tube under the EFI intake manifold. Over time O-rings become brittle and break. Replace a leaky or corroded O-rings before severe damage occurs. This is OEM toyota part and may not...

NGK Spark Plug R5672A-8 (10-18 Psi / 14:1 Comp) LC Engineering carries NGK V-Power spark plugs, which offer economical performance for your Toyota, and are the only plugs with NGK's V-Groove technology. They enhance the spark kernel, lower the voltage...

NGK Spark Plug R5671A-10 (30+ psi of Boost) NGK's V-grooved center electrode moves the spark to the outer edge of the electrode for improved ignitability in all combustion chamber conditions. This configuration is especially helpful for throttle...

Mechanical Fuel Pump Gasket Replacing the mechanical fuel pump? You may need this.....OEM Toyota mechanical fuel pump gasket. NOTE: Sold Individually. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

OE Plenum Gasket This is a OE replacement 3VZ plenum gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed. Please...

Street Distributor Rotor The distributor rotor rotates inside the distributor and transfers the high tension current from the coil to the towers of the distributor cap. The firing end of the rotor, from which the high tension spark jumps to each of the...

8" Pinion & Transfer Case Flange Nut The flange nuts are recommended to be staked or peened over to lock so they are not considered reusable. This stock replacement nut is used on the 8" pinion in the rear 1979-2002 and most transfer case flanges...

Base Gasket (Pair) Avoid or fix annoying vacuum leaks by replacing the base gaskets between your carburetor and intake manifold. We recommend this genuine Red Line Weber gasket to be replaced any time the carburetor is removed from the manifold...

Primary Idle Jet Holder (w/ O-Ring) This Weber jet holder holds the primary fat jet into the main housing on Weber 32/36 and 38 downdraft carburetors. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Secondary Idle Jet Holder (w/ O-Ring) This Weber jet holder holds the secondary skinny jet into the main housing on Weber 32/36 and 38 downdraft carburetors. Contact our Tech Support Line for further information at 928-575-2174. Note:...