1990

Blow Off Valve Weld On Fitting (You Choose Material) All our blow-off valves come supplied with aluminum adapters but if you are using a steel intake tube you will need the steel weld-on adapter, Aluminum weld-on adapters are designed to work with...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

Intake Valve (Stock Length) (Stainless Steel / 45.5mm) In 2019 LC Engineering revised it's Stainless Steel Intake Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...

PCV Relocation Kit If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

OEM "J" Bolt (Battery Hold Down) OEM Toyota "J" bolt for battery hold down bracket. OEM Toyota Part #: 74451-89103 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

10mm Rear Coil Spring Spacer (Old Man Emu) Features: Installs on the top of the rear coil spring. Designed to add 10mm lift to compensate for vehicle lean. NOTE: Sold Individually. Due to many supply chain issues, this product may be on backorder...