1991

Safety Auto Rod Bearing Set When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end.These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

PCV Hose This is the OEM 22RE PCV hose for the PCV Valve on top of the valve cover. OEM Toyota Part #: 12261-35011 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 1.25 x 48mm long, heat-treated plated header mounting studs are stronger than stock. Works with a stock...

Fuel Filter When was the last time you changed your fuel filter? Toyota recommends changing it out every 30,000 miles, but some prefer changing theirs every 15,000 for many reasons. LC Engineering carries fuel filters for your Toyota. One of the most...

Rear Main Seal High-quality silicone seals with a double lip for improved sealing. If you have a big groove worn in the crankshaft seal surface, you'll need one of our seal savers for trouble-free installation without leaks. Be sure to wipe some engine...

A/C Power Steering Idler Pulley You might need to replace A/C power steering idler pulley for your 1985-1995 22R/RE engine if the existing pulley is worn out, damaged, or making excessive noise. This pulley is crucial for maintaining proper tension on...

Fuel Pump Eccentric When eliminating the fuel pump eccentric from the stock distributor, you will need this spacer to bring the drive gear back into alignment. This is an OEM core unit processed by LC Engineering. Only used on 22R when eccentric is...

Manifold Gasket Set (Intake & Exhaust) Manifold gasket set includes both intake and exhaust manifold gaskets. OEM quality gaskets provide the best possible. Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and...

Merge Collector (3-1 1/2″ into 1-2 ¼″) You've got that header all constructed, now you just need a collector to tie it all together. LC Engineering has already done the work for you, just pick the one for your application, slip it on, and weld it...

2" ID Silicone Elbow (90º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Valve Cover Hardware Kit Valve cover hardware kit includes (4) studs and (4) chrome acorn nuts, for the 20R/22R/RE (all years). We also use the studs in this kit for mounting 1" spacers to adapters, nuts are not used. This product should not be used...

Distributor Plug This plug is designed to plug the hole in the cylinder head after removing the distributor. This is part of the Pro Fuel Injection setup we offer. Contact our Tech Support Line for further information at 928-575-2174...