1991

Water Block Plate (Center Of Head) If you are installing an Offenhauser intake (or if you are eliminating the heater core), there won't be room for the heater core outlet off the cylinder head. This water block plate goes in the center of the cylinder...

Exhaust Gasket OEM style gaskets offer the best possible seal for your stock manifold or header. All the LC Engineering headers are designed to use the factory gaskets. Traditional paper exhaust gaskets do not last as long as the factory style gaskets...

Fuel Filter A frequently overlooked tune-up component is the fuel filter. While modern gasoline is highly refined, contaminants can still get in fuel anywhere from the filling of the transport truck to particles in your own gas tank. Little bits of...

Oil Fitting (Block To Oil Filter) LC Engineering carries all the components you need to build your long block or service your old one. Specifications: 27mm Hex Head Thread pitch: 19mm x 1.5 (Block Side) & 3/4 - 16 (Filter Side) Contact...

Water Block Plate (Timing Cover Passenger Side) This block plate goes on the passenger side of the timing cover. Perfect for eliminating the unnecessary water hoses going around your engine compartment. Contact our Tech Support Line for...

Water Block Plate (Timing Cover Driver Side) This block plate goes on the driver's side back of the timing cover which is for deleting the factory heater return line on most 22's. Contact our Tech Support Line for further information at...

Fuel Injector Caps (Green Cap) These clear injector caps fit 3VZ V6 injectors. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (6). Contact our Tech Support Line for...

Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...

Fan/Alternator Belt (1975 - 1995) Pickup & 4Runner 20R/22R/RE/RET This high Performance V-Belt is designed with being a workhorse in mind, the polyester cord provides maximum power transfer and tension holding capability for the life of the belt...

OEM Shifter Boot (Square) Over time the factory shift lever boot can get worn out or start to break down and disintegrate. When this happens it can result in dirt or mud getting into the transmission shifter housing and then into the transmission. This...

Throttle Cable Up-Grade For custom applications such as sidedraft carburetors or race cars with different routing, this throttle cable end will make fabrication of a throttle cable a breeze. Simply cut the stock cable to length, attach this cable end...

Underdrive Belt (6" Street Kit) This belt is used on the LC Engineering Pulley Kit for the 6" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...