Seal Saver (Front of Crankshaft) Do you have a pesky oil leak coming from the harmonic balancer? Don't just keep swapping out front seals. LC Engineering carries this seal saver that slides right over the snout of the crankshaft and rides between the...

Silicone Coupler (2.75" ID) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Oil Pump Crankshaft Front Seal New OEM quality Oil Pump Crankshaft Seal. Eliminate those pesky front oil leaks by replacing the old brittle seal with this new high-quality seal. Contact our Tech Support Line for further information at...

GT25R Turbo Inlet Gasket (Metal) A Stainless Steel inlet gasket for the GT25 turbos that we use in our CT20 conversion kit. For between the turbo manifold and the GT25 turbo or our adaptor and the GT25. Contact our Tech Support Line for further...

Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Oil Pan Hardware Kit (Silicone Seal) This oil pan hardware kit includes all the bolts and washers needed to install your oil pan and pick up tube. This hardware kit is designed to work with silicone seal pans only. This kit will not work with gasket...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Rear Inner Axle Seal Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support Line for...

8" Oil Dipstick Tube Bracket (Shorty Style) OEM part direct from Toyota! Don't look any further for a new replacement dipstick Tube Bracket to replace your old one. This is the shorty style dipstick tube bracket found on most 22R and 22RE applications...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

OEM Shifter Boot (Manual Transmission) It's common for the factory shift lever boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transmission shifter then into the transmission. This simple rubber...

OE Wheel Bearing Grease Seal (Front Hub) Fits in the back side of the front IFS hubs, will be needed anytime you repack or replace front wheel bearings. You will need two seals in order to do your truck. NOTE: Not for Solid Axle applications. For...