Oil Cap O-Ring This oil cap o-ring fits both of LC Engineering's Billet Aluminum Oil Caps, see Part #: 1024082 as well as Part #: 1024088. All new oil caps come with this o-ring. Contact our Tech Support Line for further information at...

OEM Coolant Bypass Hose Clamp If you have ever had to connect the lines on the bottom of your throttle body, you know the foresight needed to get everything lined up properly to fit your long nose pliers in for the final step. Well, we here at LC have...

OE Knuckle Wave Washer Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...

EFI Intake Bolt (Long) M8-1.25 x 95mm Socket Head Cap Screw for use on EFI intake. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Base Gasket Fix or prevent pesky vacuum leaks at the carburetor base by replacing the gasket between your stock 22R Aisin carb and the intake manifold. Genuine Toyota quality gasket. Contact our Tech Support Line for further information at...

Throttle Body Gasket (Paper "O" Shape) Throttle body gaskets can be a source of hard-to-find vacuum leaks if the throttle body is removed or disrupted. Any time you remove your throttle body, you should replace the gasket while you're at it. On the 3.4...

Throttle Body Gasket Throttle body gaskets can be a source of hard-to-find vacuum leaks if the throttle body is removed or disrupted. Any time you remove your throttle body, you should replace the gasket while you're at it. This is a stock replacement...

Dowel Pin (Aligns Cylinder Head To Block) When installing a new head on your 20R, 22R or 22RE, these dowel pins can make head gasket alignment much easier. by installing these in the block, the gasket and cylinder head all fit snugly and perfectly...

OEM Vent Hose Spring Clamp Need to connect the vent hose and secure it properly? Simply get these spring clips into place, and release. Nothing makes a job easier than having proper fitting replacement parts. Look no further, LC has you covered. OEM...

Holley Base Gasket Avoid annoying vacuum leaks and replace the gasket any time you remove the carburetor from the intake. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Idle Jet Holder O-Ring These O-Rings seal the idle jet holder to the main carburetor housing. O-Rings can become brittle with age and cause annoying (and dangerous) fuel leaks. NOTE: O-Rings sold individually. Contact our Tech Support Line for...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...