Engine Rebuild Oil Galley Plug Kit Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off after cleaning. LC Engineering can supply you with all these hard to find plugs. Most engines have some sort of...

Fuel Pressure Bolt Kit Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? This new fuel bolt kit is the solution to the problem. This kit will replace the banjo bolt on the cold start...

Shim Pack (Six Shooter Knuckle) Shim pack for 6-shooter knuckles. In order to maintain proper steering geometry and prevent binding or mis-alignment, we offer this assortment of shims. Contact our Tech Support Line for further information at...

PCV Hose This is the OEM 22RE PCV hose for the PCV Valve on top of the valve cover. OEM Toyota Part #: 12261-35011 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...

Fuel Filter When was the last time you changed your fuel filter? Toyota recommends changing it out every 30,000 miles, but some prefer changing theirs every 15,000 for many reasons. LC Engineering carries fuel filters for your Toyota. One of the most...

Temperature Gauge Sender This Temperature Gauge Sender is a stock replacement for 22RE engines. After years of use, electric components can go bad and give false readings, that is why we recommend replacing them with new ones, for accurate readings...

Rear Main Seal This is an OEM Toyota seal, so you know you're getting the best! High-quality silicone seals with a double lip for improved sealing. If you have a big groove worn in the crankshaft seal surface, you'll need one of our seal savers for...

A/C Power Steering Idler Pulley You might need to replace A/C power steering idler pulley for your 1985-1995 22R/RE engine if the existing pulley is worn out, damaged, or making excessive noise. This pulley is crucial for maintaining proper tension on...

Fuel Pump Eccentric When eliminating the fuel pump eccentric from the stock distributor, you will need this spacer to bring the drive gear back into alignment. This is an OEM core unit processed by LC Engineering. Only used on 22R when eccentric is...

Coil Adapter Wire (20" Long) Have you updated the ignition on your 20R/22R/22RE/3VZ but haven't gotten around to replacing the distributor yet? No problem, LC Engineering has that special coil wire to connect a Fast Ignition to Stock Distributor...

Rear Main Seal OEM replacement rear main seal. This will install on the big end of the crankshaft. If there is a large groove on the crank seal surface be sure to get our seal saver for trouble-free installation. For the Seal Saver, see Part #:...

O-Ring & Isolator Kit O-Ring and Isolator set for Weber sidedraft carburetors. Kit Contains: (2) Plastic O-ring plates (4) O-Rings (4) Springs NOTE: Each kit will only service (1) carburetor, make sure you order (2). Contact our Tech...