Breather Hose (Front Of Valve Cover) OEM Toyota hose comes off the valve cover and goes to intake manifold. OEM Toyota Part #: 12262-35060 NOTE: Not for carbureted applications, for carbureted models, see Part #: 1072413 (1984), or Part #: ...

Turbo Oil Drain Plate (1/2" NPT Boss / Turbo Side) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This drain plate mounts to the bottom of the turbo and gives you a 1/2" NPT bung to...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

T3 Turbo Discharge Gasket (4 Bolt) Stainless Steel T3 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Valve Keepers It is recommended to use hardened valve keepers every time you re-build your engine. LC Engineering carries hardened valve keepers for all 3VZ valves using stock Toyota retainers or Street Performer retainers. A must for any high RPM...

K&N Filter Care Service Kit (Squeeze Red / 99-5050) K&N Recharger Kit 99-5050 is designed for cleaning your K&N oiled cotton air filter when it is time to be serviced. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil...

K&N Power Kleen Filter Cleaner (99-0621) K&N part 99-0621 is a 32 ounce pump spray bottle of Power Kleen Air Filter Cleaner. K&N Power Kleen is the only cleaner recommended to clean K&N cotton air filter elements. K&N 99-0621 Air Filter Cleaner will...

22RE Cold Start Injector Block Plate Kit (22RE EFI Intake Manifold) This kit is designed to allow you to safely block of the cold start injector and supply when you are upgrading your efi system to a stand alone fuel management. NOTE: For a complete...

Turbo Wristpin LC Engineering can supply replacement wrist pins and locks for our forged pistons. Wristpins are available in either standard thickness (.120") or "Turbo" version (.155"). These pins are designed to fit our forged pistons only and are...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

Idle Speed Adjusting Screw (w/ O-Ring) Is your Idle Speed Screw loosening by itself keeping the motor from idling properly? Is it stripped out from all of the adjustments over the years? Is it even on the throttle body anymore or did it fall out? LC...

Front Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. It is recommended to use Anti-seize when installing...