Intake Valve (Stock Length) (Stainless Steel / 45.5mm) In 2019 LC Engineering revised it's Stainless Steel Intake Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...

PCV Relocation Kit If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

10mm Rear Coil Spring Spacer (Old Man Emu) Features: Installs on the top of the rear coil spring. Designed to add 10mm lift to compensate for vehicle lean. NOTE: Sold Individually. Due to many supply chain issues, this product may be on backorder...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley without alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...