1994

Weber Gasket Kit If you just need to freshen up the gaskets on your Weber carburetor, this kit if for you. It does not include any accelerator pump diaphragms or other parts included in a complete rebuild- only the gaskets. Contact our Tech...

Fuel Pressure Gauge (1.5" Diameter / 0-60 Psi) These fuel pressure gauges are for EFI engines that run low fuel pressures. They are compact and accurate, using a 1 1/2 in. diameter durable, rust-free, stainless steel bezel and case and a crisp,...

Hall Sensor Mount This bracket is needed if you are installing our Pro Fuel Injection Systems on a 22RE engine. This mount will locate the Hall sensor in the right location for both the stock pulley and the LC Engineering underdrive pulley. This...

OEM Bell Housing to Block Bolt Set After many years of sitting in your engine compartment, the bell housing bolts might not be in the best shape, especially if you've had the engine or trans out a few times. Instead of scrambling to replace a bolt or...

Engine Rebuild Oil Galley Plug Kit Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off after cleaning. LC Engineering can supply you with all these hard to find plugs. Most engines have some sort of...

K&N Filter Care Service Kit (Aerosol / 99-5000) K&N Recharger Kit 99-5000 is designed to service your K&N oiled cotton air filter when it gets dirty. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil. The 99-5000 Recharger...

K&N Sealing Grease (99-0704) K&N Sealing Grease 99-0704 provides an airtight fit around sealing surfaces on all types of air filter elements. It resists heat and will not melt or run off. K&N Sealing Grease is designed to ensure the filter stays sealed...

Safety Auto Rod Bearing Set When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end.These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

PCV Hose This is the OEM 22RE PCV hose for the PCV Valve on top of the valve cover. OEM Toyota Part #: 12261-35011 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 1.25 x 48mm long, heat-treated plated header mounting studs are stronger than stock. Works with a stock...

Fuel Filter When was the last time you changed your fuel filter? Toyota recommends changing it out every 30,000 miles, but some prefer changing theirs every 15,000 for many reasons. LC Engineering carries fuel filters for your Toyota. One of the most...

Temperature Gauge Sender This Temperature Gauge Sender is a stock replacement for 22RE engines. After years of use, electric components can go bad and give false readings, that is why we recommend replacing them with new ones, for accurate readings...