1994

Blow Off Valve Weld On Fitting (You Choose Material) All our blow-off valves come supplied with aluminum adapters but if you are using a steel intake tube you will need the steel weld-on adapter, Aluminum weld-on adapters are designed to work with...

Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

Intake Valve (Stock Length) (Stainless Steel / 45.5mm) In 2019 LC Engineering revised it's Stainless Steel Intake Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley without alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...