1994

Wristpin Locks (.866" Diameter) This set of wrist pin locks is what is required to hold your connecting rod wrist pins in place. These are essential pieces that should not be overlooked. Always replace wrist pin locks when refreshing your motor...

Trail Gear Brake Line Clip & Mount (Rear Line Only) This brake line mount kit is designed to fit Trail Gear extended length brake lines. If you've added a little (or a lot) extra ground clearance and suspension travel, you probably have added some...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

Inner Axle Seal When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your tool box for trail side repairs. This product should...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Fuel Pump Tank Seal This is an OE fuel pump tank seal. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact...

Fuel Pump Lock Ring Seal If you find yourself replacing a fuel pump, now is the time to replace the lock ring seal as well. This is an OE fuel pump lock ring seal to help you through the job. Contact our Tech Support Line for further information...

OEM PCV Valve (Steel) This is an OEM Toyota 3VZ PCV valve. OEM Toyota: 12204-65010 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...

Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...

Pro Bronze Valve Guide Valve Guides are made of the highest quality manganese bronze material available. This provides additional clearance between retainer and seal for increased valve lift. Valve Guides provide excellent stability so they can be run...

Exhaust Valve (Steel / 35mm - Stock Size) If you're looking for replacement valves for your Toyota 3VZ engine, then these high-strength steel OE type replacement valves are just right for you. These valves utilize the factory size valve seats and valve...