1995

Pulley Bolt (Front Balancer) OEM Toyota front crank hub bolt fits all 2RZ and 3RZ engines. We recommend replacing the balancer bolt any time you replace the front balancer. OEM Toyota Part #: 90105-16041 Contact our Tech Support Line for...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

OE Breather Hose (Front Of Valve Cover) OE Toyota hose comes off the valve cover and goes to intake manifold. Replaces OEM Toyota Part #: 12262-35060 NOTE: Not for carbureted applications, for carbureted models, see Part #: 1072413 (1984), or Part...

Rear Inner Axle Seal Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support Line for...

8" Oil Dipstick Tube Bracket (Shorty Style) OEM part direct from Toyota! Don't look any further for a new replacement dipstick Tube Bracket to replace your old one. This is the shorty style dipstick tube bracket found on most 22R and 22RE applications...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

OE PCV Hose This is the OE 22RE PCV hose for the PCV Valve on top of the valve cover. Replaces OEM Toyota Part #: 12261-35011 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

OE Wheel Bearing Grease Seal (Front Hub) Fits in the back side of the front IFS hubs, will be needed anytime you repack or replace front wheel bearings. You will need two seals in order to do your truck. NOTE: Not for Solid Axle applications. For...

Gasket Set (Weber Adapter) Avoid or fix annoying vacuum leaks by replacing the gaskets between the plates the Weber 32/36 and 38 carb adapter. Over time gaskets become brittle and break. We recommend these gaskets to be replaced any time the adapter is...

Pro Chromoly Retainer (Dual Spring) For hot street motors or moderate race motors, the Chromoly retainers fit the bill nicely. Use these with our dual valve springs for proper valvetrain control up to 6,000 RPM. These retainers are substantially...

1/2" Pushlock To -8AN (45 Degree Swivel AN Fitting) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Fuel Injector Caps (Green Cap) Replace those old brittle troublesome caps with a new set through LC Engineering. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type C...